Fitting

 Top  Previous  Next

VLXE supports fitting of parameters to all 3 systems types:

•Standard
•Standard/Standard
•Standard/Polymer

 

The fitting can be done by using a function call but that is not recommended since running a fit may take some time depending on the system.

Instead 2 wizards has to be used. One that create the "Fitting project sheet" and one to run the calculation.

 

The "Fitting project sheet" holds all the data and fitting settings + has room for the result of the fitting.

A fit is run by 3 steps:

1.Use the wizard to create a: "Fitting project sheet"
2.Add data to the colored areas in the fitting sheet
3.Open the wizard that runs the fit.